积分浊度计在沙尘暴监测网试验中应用分析

中国气象局在沙尘暴监测网各站点安装了积分浊度计，这是国内首次利用积分浊度计进行大面积气溶胶光学性质的监测。文章选取北京观象台2003年9月2日至11月18日散射系数数据以及部分PMIO质量浓度数据，结合气象资料分析了观测期间散射系数的变化特征，散射系数与PMIO质量浓度以及能见度的关系，得出观测期间散射系数的平均值(标准偏差)为306．2Mm^-1(292．78Mm^-1)；风速对散射系数有重要影响；散射系数与PMIO质量浓度有较好的相关性(r=0．761)，与能见度存在负相关关系(r=-0．716)。     

XLS-Ⅱ型系留气艇探测系统

简单描述了系留气艇运动的基本力学原理，较详细地介绍了国产XLS-Ⅱ型系留气艇探测系统的基本组成、结构和主要技术指标。系统的绞车重36kg，电机功率600W，拉线最大拉力为175kg。与系统配套的有气象要素、大气臭氧和大气气溶胶等探测单元。给出了主要气象和某些环境要素的探测精度和应用实例并简单讨论了系留气艇探测系统在实际应用的某些问题。     

中国地区沙尘气溶胶输送过程的数值模拟

本文建立了一个包含沙尘起沙、输送、干沉积和湿沉积过程的气溶胶输送扩散模式．并和中尺度气候模式RIEMS相连接研究了1998年1月、4月、7月和1997年10月的沙尘起沙、输送、干沉积和湿沉积的过程。计算1998年1月、4月、7月和1997年10月气溶胶浓度及其分布．并和这四个月份的平均起沙分布以及北京、郑州和南京的实例沙尘分布作了比较．结果表明我国起沙多发生在春季．同时春季也是我国沙尘强度最大的季节。沙尘在我国西北的沙地和沙漠地区起沙后．向我国的东南方向输送．在输送过程中沙尘浓度逐渐降低。     

若干风蚀粉尘释放模型述评

粉尘气溶胶对大气、陆地和海洋多方面的影响促进了粉尘释放的模拟研究。Gillette和美国FPA的粉尘释放模型相对地比较简单，主要考虑了摩阻速度和土壤质地对粉尘释放的影响，没有考虑粉尘释放过程的微观机制；邵亚平和Alfaro等人的DPM粉尘释放模型都通过土壤粒度分布、粗糙度和起动摩阻速度等参数表达了地表特征对粉尘释放的影响，且都描述了粉尘释放的微观机制。20多年来粉尘释放的模拟研究取得了重要进展，主要表现在通过室内和野外实验证实了粉尘释放的主要机制为跃移颗粒的冲击，并分别从粉尘的结合能与跃移颗粒动能及跃移颗粒产生的弹坑体积角度来描述这个微观机制。然而所有的模拟工作只是从某一方面反映了粉尘释放过程，对粉尘释放机制还没有完全了解清楚，特别的是目前关于粉尘结合能研究还有很大的不确定性，这也是粉尘释放模型需要改进的地方。     

Size-Resolved Aerosol Characterization for a Polluted Episode at the IfT Research Station Melpitz in Autumn 1997

Inorganic ions, organic carbon (OC), elemental carbon (EC) and a variety of organic single species in airborne particles have been determined at the research station of the Leibniz – Institut für Troposphärenforschung (IfT) in Melpitz (Germany) in autumn 1997.Samples of eight selected measurement events were divided in two groups in order to investigate differences in the chemical composition of particles originating from southwesterly (SW – developed EU countries) or from easterly directions (E – less developed eastern countries). Differences between these two groups were tested statistically by Student's t-test.Five stage cascade impactor samples show nitrate as most abundant in the accumulation mode in the SW group. EC and sulphate show the most abundant mass fractions in the E group. That can be considered as a consequence of domestic coal heating and coal-fired power plant emissions in the region of westerly Poland, northern Czech Republic and easterly Germany. Higher nitrate concentrations in the SW group can be explained by stronger NO _x emissions caused by the leeward plume of the conurbation of Leipzig, as well as by the still higher traffic density in western Germany.The methane sulphonic acid (MSA) mass fraction was higher for SW air masses in accumulation mode particles, probably indicating marine origin. Succinic acid also showed higher mass fractions for the SW group. This could be caused by primary emission in automobile exhaust gases and photochemical formation during transport from SW. Indeed, during SW sampling, solar radiation intensity was higher than during E sampling.The observed differences in the particle composition are an expression of the still existing technology gradient in Europe. Future campaigns could show the development to a joint economy with smaller differences in anthropogenic emissions.     

硫酸盐直接辐射强迫的在线与固定转化率模拟方法的对比研究

以2000年1、4、7、10月为例，利用区域气候模式，比较了模拟硫酸盐气溶胶分布和直接辐射强迫的在线模拟方法与固定SO2到硫酸盐转化率方法，并与全球模式的结果进行了对比检验。结果表明：在线模拟得到的主要结果与全球平均结果符合得很好，但固定转化率方法存在明显偏差；两种方法硫酸盐柱含量的差异在-4-12mg／m^2范围内，占在线模拟柱含量的42％以上，7月份差异最显著，1月份差异最小；大气顶辐射强迫差异在-1.8-0．4W／m^2之间，此差别占在线辐射强迫的26％以上；采用36．7％的固定转化率对冬季过大、夏季偏小，只有春秋季的江南部分地区适合。由于固定转化率方法不能反映温度、辐射、水汽、云水等气象要素的季节性变化对硫酸盐生成率的影响，因而对硫酸盐含量和分布的季节变化模拟存在偏差，这是导致上述差异的重要原因。     

Simulation of secondary aerosols over North China in summer

The comparisons of observed and simulated NOx, CO, O3, NH3, HNO3, SO2 and PM2.5 indicate that CMAQ model can simulate variations of pollutants over North China well.Moreover, the model results show that high NH3 is in Hebei, Henan and Shandong provinces,with average concentration of (30-35)×10-9. The results of the sensitive experiment indicate that high concentration of NH3 has the efficiency of the production of secondary sulfate aerosol increase by more than 30%, especially at the juncture of Handan, Anyang and Changzhi that increased by 50%. In addition, NH3 also produces secondary ammonia and nitrate aerosol, and the sum of them is approximately equal to sulfate aerosol. The height of planetary boundary layer (PBL) in Beijing is higher in daytime, with average height of 1500 m at noon. This makes SO2,NH3 and HNO3 transported into upper PBL of 850 hPa. The high secondary sulfate, and ammonia and nitrate aerosol happen in the upper and lower PBL, respectively. Because PM2.5 lifetime is relatively long, it can be transported into the middle troposphere to form a thick aerosol layer,which is the arched roof of aerosol. The model result suggests that if the aerosol concentration in North China would be controlled, the reduction of NH3 emission is one of efficient ways besides the reduction of primary SO2, NOx and aerosol emission.     

Application of MODIS satellite products to the air pollution research in Beijing

The direct correlation between NASA MODIS aerosol optical depth (AOD) products and the air pollution index (API) in Beijing was found relatively low based on the long-term comparison analysis. The correlation improved to some extent after taking account of the seasonal variation of scale height and the vertical distribution of aerosols. The correlation coefficient further improved significantly after considering the influencing factor of Relative Humidity (RH). This study concluded that satellite remote-sensing could serve as an efficient tool for monitoring the spatial distribution of particulate pollutants on the ground-level, as long as corrections have been made in the two aforementioned processes. Taking advantage of the MODIS information, we analyzed a pollution episode occurring in October 2004 in Beijing. It indicated that satellite remote-sensing could describe the formation process of the ground-level pollution episode in detail, and showed that regional transport and the topography were crucial factors to air quality in Beijing. The annual averaged distribution in the urban area of Beijing and its surroundings could be also obtained from the high-resolution retrieval results, implicating that high-resolution satellite remote-sensing might be potential in monitoring the source distribution of particulate pollutants.     

下地幔矿物研究及其进展

文中综述了20世纪90年代以来对下地幔矿物高温高压研究的进展,详细评论了下地幔温压下(Mg,Fe)SiO3钙钛矿的稳定性、(Mg, Fe)SiO3 钙钛矿和(Mg, Fe)O镁方铁矿的高压状态方程和热弹性及高压熔化、核幔边界温压下铁和硅酸盐的化学反应等几个热点问题;探讨了下地幔的矿物学组成,对下地幔的地震波速异常给出了可能的矿物学解释;介绍了国内同领域的研究工作;展望了下地幔矿物研究的发展方向。     

A new method to calculate end-member thermodynamic properties of minerals from their constituent polyhedra II: heat capacity, compressibility and thermal expansion

Thermodynamic calculations in petrology are generally performed at pressures and temperatures beyond the standard state conditions. Accurate prediction of mineral equilibria therefore requires knowledge of the heat capacity, thermal expansion and compressibility for the minerals involved. Unfortunately, such data are not always available. In this contribution we present a data set to estimate the heat capacity, thermal expansion and compressibility of mineral end‐members from their constituent polyhedra, based on the premise that the thermodynamic properties of minerals can be described by a linear combination of the fractional properties of their constituents. As such, only the crystallography of the phase of interest needs to be known. This approach is especially powerful for hypothetical mineral end‐members and for minerals, for which the experimental determination of their thermodynamic properties is difficult. The data set consists of the properties for 35 polyhedra in the system K–Na–Ca–Li–Be–Mg–Mn–Fe–Co–Ni–Zn–Al–Ti–Si–H, determined by multiple linear regression analysis on a data set of 111 published end‐member thermodynamic properties. The large number of polyhedra determined allows calculation of a much larger variety of phases than was previously possible, and the choice of constituents together with the large number of thermodynamic input data results in estimates with associated uncertainty of generally <5%. The quality of the data appears to be sufficiently accurate for thermodynamic modelling as demonstrated by modelling the stability of margarite in the CASH system and the position of the talc–staurolite–chloritoid–pyrope absent invariant point in the KMASH system. In both cases, our results overlap within error with published equivalents.